In-line solution heaters are the most direct way to warm solutions flowing into a Series 20 Imaging and Recording Chamber.
In-line solution heating is the simplest and most effective method of warming perfusion solutions. The heater is connected to the chamber with a short length of tubing such that the warmed perfusate flows directly into the chamber bath. Depending on bath volume and other factors, in-line solution heating alone by it self may be sufficient for many applications.
In-line solution heaters from Warner Instruments are used to warm perfusate solutions as they flow into a chamber (such as our Imaging and Recording Chambers). Their small size allows for placement close to the chamber input allowing the perfusate to be warmed immediately prior to entry. The SH-27B is our rapid flow in-line solution heater. It is ideal for perfusion flows up to 10 ml/min while the SF-28 is recommended for applications requiring solution flow rates of less than 2 ml/min.
Temperature control is maintained by an internal feedback thermistor (i.e. T1 on the heater controller) which senses the temperature at the outflow end of the heater. This sensing thermistor is located outside of the solution path and is therefore not subjected to corrosive salts or careless cleaning.
Each heater is also supplied with a Model TA-29 monitor thermistor cable assembly (as shown on the right) which allows for monitoring the actual bath temperature (T2 output on the heater controller). Solutions are gradually warmed as they flow from input to output resulting in minimal outgassing. Heater input and output lines accept standard 1/16" OD (PE-160) tubing.
|Voltage Requirement||Variable 0 to 12 VDC max.|
|Internal Dead Volume||260 μl|
|Maximum Flow Rate at 37°C|
|Body||12.5 mm x 12.5 cm (D x L)|
|Bath thermistor dimensions||0.85 x 4.6 mm|
|Temperature of 37°C can be maintained at ± 0.2°C under following conditions:|
|Condition A||Solution temperature at input (nominally 21°C) varies no more than ±10%|
|Condition B||Solution flow rate varies no more than 25%|
|QE-1 Quick Exchange Platform with SH-27B In-Line Heater: heating with perfusion.|
|TC-344B Temperature Controller:|
|QE-1 Set Temperature||38C|
|SH-27B Set Temperature||40C|
|Flow Rate||2 ml/min.|
Last Revision 1.9.13
Customers from Europe and Australia can use the Multi Channel Systems - Online Shop to order Warner products or create quotes.
|Order No.||Model No.||Product Description||USA Price||Order|
|64-0102||SH-27B||In-line solution heater||Login||Login|
|64-0103||SF-28||Slow flow in-line solution heater||Login||Login|
|Accessories and Replacement Parts|
|64-1555||SHH-1||Holder for SH-27B and SF-28 inline solution heaters||Login||Login|
|64-0107||TA-29||Cable with bead thermistor||Login||Login|
|64-0108||TA-30||Cable with glass thermistor||Login||Login|
|64-2400||TC-324C||Heater controller, single channel, 110-230 VAC, 50/60Hz||Login||Login|
|64-2401||TC-344C||Heater controller, dual channel, 110-230 VAC, 50/60Hz||Login||Login|