A sealed water bath which is connected to your pumped source of constant temperature water.
Six 'active' cells for use in respiration measurements.
Six 'parking' cells to keep the oxygen sensors at the correct temperature when not in use.
Six electrode holders which can be adjusted to set the volume in the 'active' respiration cells to between 1.0 and 3.0 mL (user calibrated).
A 6-position 12 volt magnetic stirrer unit.
The RC650 was designed for use with the 929 Six-Channel Oxygen Meter, for replicate respiration measurements of cell suspensions, microbial suspensions, mitochondria or enzyme preparations. Respiring preparations in metabolic studies are often conducted at 37ºC and have a fast time course. For these studies, it is preferable to use 12.5 µm FEP membranes which have a very fast speed of response (i.e. typically 95% of full response within 6 - 8 secs). These membranes have to be mounted on special electrode jackets (p/n 69-3011) which have a very fine capillary hole opposite the anode. This hole prevents distension of the membrane which would otherwise be caused by pressure building up as the electrode jacket is screwed on.
The respirometer is comprised of a sealed water bath containing both 'active' and 'parking' respirometer cells located above a six-position magnetic stirrer. The six 'active' cells are at the front of the bath and are accurately centered over the coils of the magnetic stirring unit beneath. Each cell is sealed by a neoprene 'O' ring. The volume of the 'active' cells may be set between 1 and 3 mL, by rotating the knurled collar of the electrode holders.
The rear of the bath contains a further six 'parking' cells which are used to park the electrode holders and maintain them at a constant temperature while changing the contents of the respiratory 'active' cells. For easy removal and cleaning the cells are sealed into the water bath by O-rings.
Each electrode holder has an aperture through which the membrane tip of the 1302 Oxygen Sensor protrudes, making a sliding fit into the cells. As the holder is inserted into the preparation, the sloping face at its tip gathers the air into the slot, which runs the complete length of the holder. Respiratory inhibitors or other solutions can be injected directly into the cell via this slot, using a fine bore needle (included).
The electrode holders are made from black acetal. The electrode is positioned in the holder by pressure exerted by the cap on three O rings at the cable-entry end of the electrode. This seals the nose of the electrode against the precision shaped plastic tip of the holder, so that only the membrane-covered cathode protrudes.
For replicate respiration measurements of cell suspensions, microbial suspensions, mitochondria or enzyme preparations.
Enables up to six replicate respiration experiments
Uses the advanced recording and analysis features of the 929 Six-Channel Oxygen Meter and included software
Integral unit complete with six-position magnetic stirrer
Good visibility of cell contents
Variable cell volume of 1 to 3 mL
Diameter of Cells
Volume of Cells
1 to 3 mL (adjustable)
Precision bore glass
Black acetal, with peek tip
Clear and black acrylic
6-position; 12 VDC
from external plugtop power supply,
100-230 V, 47-63 Hz.